Linux管理员在工作时有可能会遇到各种各样的问题,如需要设置Linux不同网段访问这个工作,乍一听起来还是有点难度的。本实例通过说明:实现10.0.0.0/24网段与192.168.2.0/24网段相互访问.帮你明白这一个问题解决方式。
Linux不同网段访问设置步骤1:查看本机IP地址 [root@localhost root]# ifconfig eth0 Link encap:Ethernet HWaddr 00:0C:29:A7:6E:77 inet addr:10.0.0.120 Bcast:10.0.0.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:2418 errors:0 dropped:0 overruns:0 frame:0 TX packets:1293 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:1000347 (976.9 Kb) TX bytes:192592 (188.0 Kb) Interrupt:10 Base address:0x2024
Linux不同网段访问设置步骤2:添加路由规则 [root@localhost root]# route add -net 192.168.2.0/24 eth0
Linux不同网段访问设置步骤3:查看路由规则 [root@localhost root]# route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 10.0.0.0 * 255.255.255.0 U 0 0 0 eth0 192.168.2.0 * 255.255.255.0 U 0 0 0 eth0 169.254.0.0 * 255.255.0.0 U 0 0 0 eth0
注:route规则中,必须同时存在两个网段,否则,一个网段的IP地址将无法访问到另一网段的IP地址。
Linux不同网段访问设置步骤4:检测本地机(IP:10.0.0.120)与远程机(IP:192.168.2.80)是否可互访. [root@localhost root]# ping 192.168.2.80 PING 192.168.2.80 (192.168.2.80) 56(84) bytes of data. 64 bytes from 192.168.2.80: icmp_seq=1 ttl=127 time=5.51 ms 64 bytes from 192.168.2.80: icmp_seq=2 ttl=127 time=3.17 ms
Linux不同网段访问设置步骤5:删除路由规则 [root@localhost root]# route del -net 192.168.2.0/24 eth0
【编辑推荐】
- 全面剖析Linux系统管理命令w
- 全面总结Linux快捷键的使用
- 举例说明Linux压缩命令(一)tar
- 总结Linux压缩解压的所有命令
- 详细介绍Linux软件包依赖问题
【责任编辑: 仲衡 TEL:(010)68476606】
|