Revised: November 12, 1996 Page 1 of 1
SAFETY BULLETINS ARE RECOMMENDED GUIDELINES ONLY; CONSULT ALL APPLICABLE RULES AND REGULATIONS
SAFETY BULLETINS MAY BE VIEWED OR DOWNLOADED FROM THE WEBSITE WWW.CSATF.ORG
C:\Documents and Settings\Dhoward\Local Settings\Temporary Internet Files\OLK45\SftyBull #08 ADDENDUM B.doc
INDUSTRY WIDE LABOR-MANAGEMENT SAFETY COMMITTEE
SAFETY BULLETIN #8
GUIDELINES FOR INSERT CAMERA CARS
ADDENDUM "B" - CAMERA BOOM VEHICLES
All camera boom vehicles shall be subject to all requirements outlined in Safety Bulletin
#8, "Guidelines for Insert Camera Cars."
The speed of the camera boom vehicle shall never exceed the safe operating speed set
forth by the individual manufacturer or which may endanger the safe handling of the
vehicle or safe operation of the boom arm as determined by the driver/operator.
Any person riding the boom arm shall wear an approved seat belt at all times.
Always rehearse shots under controlled conditions to ascertain safety in movement not
only of the vehicle but the boom arm as well.
Camera personnel shall only mount and dismount when given permission by the
operator in control of the camera arm. Arm balance must always be maintained.
Always use wheel chocks to prevent crane movement on a sloped surface. Rachet lock
brakes for added temporary security. Never trust hydraulic brakes for permanent hold.
Maximum payload on boom arm nose should never be more than can be balanced by
the counter weight system supplied with the crane.
Payloads must be decreased in proportion to length of extensions.
On any extension configuration, check with the manufacturer or qualified operator for
allowable load.
The camera boom vehicle and boom arm shall be checked before and after use by a
qualified experienced driver/operator, and that operator must be present during any use
of the vehicle or boom arm. The driver/operator shall have the authority to make any
adjustments that may affect the safe operation of the vehicle and/or boom arm.
When a boom arm is being used, special consideration must be given to Sections 6 (a)
and (b) of "Guidelines for Insert Camera Cars of Bulletin #8."
|
|